ORDER ONLINE OR OVER THE PHONE: 01604 499 332

NS-V-20-800 Variable Force Gas Strut

TIER PRICES
  • QUANTITYPRICE
  • 6 + £217.60
  • 20 + £183.24
  • 50 + £160.34
  • 100 +Contact Us
In stock
CODE
NS-V-20-800
OLD CODE
SD05-800
PRICE £229.05
  • Product code
    Product Description
    Stock Status
  • NS-V-20-800
    NS-V-20-800 Variable Force Gas Strut
    1 - 25
  • B16
    Ball Joint End Fitting with 14mm Thread B16
    50+
  • E14
    Eye End Fitting with 14mm Thread E14
    50+
  • C4
    Clevis Fork with 14mm Thread C4
    50+
  • C4-CLIP
    C4-CLIP 14mm Clevis Fork Clip
    50+
More Information
Stroke 800mm
Extended Length 1711mm
Rod Diameter 20mm
Body Diameter 40mm
Force Range 300 - 5000N

INSTALLATION INSTRUCTIONS

For standard compression gas struts we advise the use of ball joints to alleviate possible side loading, and uneven wearing of the piston rod/seals. Install the strut, piston rod down, for optimum lubrication of the guide and sealing system at all times. Always install the strut in its relaxed state. It is advisable to keep the strut in a single plane of movement. Failure to adhere to this advice may result in a reduced lifespan of the strut. Ensure that the end fittings are tightly fastened onto the thread of the gas struts prior to fitting. If the end fittings require aligning, the piston rod of the gas strut can rotate inside the body (cylinder). Place and hold the piston end fixing on a flat surface, grip the cylinder and firmly twist it until the end fitting is aligned correctly.

FITTING BRACKETS

When utilising a bracket with a ball stud/end, the procedure to fit it to the relevant ball joint fitting is as follows:

  • Remove the retaining clip from the ball socket by rotating it from around the collar of the socket, and then pull it out from the two locating holes.
  • Ensure the ball socket is fully tightened onto the thread of the strut. Then, using a vice or pair of pliers, grip the ball stud and with a rotating motion, remove the ball stud from the socket.

FORCE ADJUSTMENT

  • Fit the gas struts with the cylinder uppermost; this prevents oil escaping while venting, and keeps the internal seals lubricated for optimum lifespan.
  • Using the allen key provided, undo the grub screw anti-clockwise a quarter turn and vent gas for 1 second, retightening the grub screw. Do not over tighten the grub screw.
  • Repeat this process on the second gas strut, venting an equal amount. Only release the pressure in short bursts to avoid venting too much gas. Each 1 second burst will lower the force by approximately 20N - 50N depending on the range.
  • Test the application by attempting to close the panel and repeat the venting process if the struts are still too powerful.
  • Once the gas struts have been adjusted, gently brush the grub screw with washing up liquid. If gas can be seen bubbling through the liquid then the grub screw requires further tightening.

For advice on how to safely mount gas struts call our technical line: 01604 499332.

Gas struts are filled with high pressure nitrogen, they should be protected from damage; never open, modify, drill, weld or subject gas struts to excessive heat.

Struts End Fittings
Struts Brackets
Catalogues
Documents
Struts Variable
Struts End Fittings
Struts Brackets
Struts Variable