Tensioning Washers

Tensioning Washers

Compliant with DIN 6796, our tensioning washers are robustly dimensioned and designed for use in medium or high load screw joints.

The high spring force of our tensioning washers affords effective protection against relaxation and creep. Especially when joints are exposed to high stresses and movements resulting from thermal expansion or contraction. In such instances, tensioning washers should replace conventional lock washers.

You can stack tensioning washers in series or parallel. Series stacking increases the available deflection of the spring stack while parallel stacking increases the force — the desired installation is to get the washers as near to flat as possible.

Contact Our Experienced Team Today

As spring manufacturers, we can advise you on the use or application of our products. If you need guidance, please contact us using our online form or directly by calling us on 01604 499332.

Legend:

FL = Free Length

F1 = Maximum Force

h min = min dimension after setting test acc to DIN 267-26

Min residual spring force = after load with the contact force and release through a travel of 20 μm

Contact force = forces for the setting test, acc to DIN267-26

Standard steel range:

Material: EN 10132-4
Finish: Mechanically galvanised and yellow chromated
Working temperature: max 120 °C

1 kp = 9.80665 Newtons, 1 Newton = 0.10197 kp

Bespoke range:

If required, untreated spring washers can also be supplied direct from the factory. Spring washers in custom sizes and special materials, e.g. stainless, acid proof, phospor bronze, Alloy 718 or Alloy 90, can be produced upon request.

PTABLE_034

15 Items

Set Descending Direction
per page